![]() If you don't trim too much the flange of the trim ring should still be able to cover the gap. If the gap between the box and drywall is too tight, you can carefully trim the drywall back to gain access to the lock ring that secures the valve to the box. Pull off the plastic trim ring around the box to gain some access. No matter whether they used crimp ring, clinch ring or an expansion type connection, the fitting should turn inside the tubing without creating a leak. After turning on the water (and verifying no leakage) I ran a gallon of water out the front dispenser. I slid the tube into the water inlet valve and tightened the compression nut. I cut the copper tube with a pipe cutter, and I slipped a compression nut and sleeve on the line. Since you have PEX water lines, the easiest would be to just try and clock the valve. I had an existing 1/4 ' copper tube that I used as a water supply line. Something more like a hydraulic fitting, but those fittings are not interchangeable with this. ![]() In order to tighten and get a particular orientation the elbow would need to have a swivel nut. ![]() This type of fitting does not seal with the threads, but rather with the flare. Don't think you'll find an elbow to connect directly to a compression fitting, I doubt anyone makes a fitting like that for standard water line connections, I know I've never seen one. Compression can be loosened (with the water off) and then turned.Ĭlick to expand.I wondered that as well, couldn't see enough info on the valve assembly for any attempt to research the valve for comparison. Expansion, crimp and cinch fittings can all be forced to rotate a little, yes, even under pressure (just be gentle, and maybe a drop will escape while you're turning it). The PEX construction is an approved alternative to copper lines and it provides better tasting ice and water. Used to connect your ice maker to water supply. Can you somehow pull the box out? If it's supplied by PEX, you WILL be able to rotate the PEX on the fitting so long as it's not sharkbite or compression. This product is certified lead free for safe drinking. It should be at a 45 degree angle so you don't have this issue. It'll stick out maybe only 1/2" more.īut before you go there, having the compression face straight out is crazy. The alternative would be to find a female compression to male NPT fitting, and a female NPT to male compression street elbow. WBTEER Refrigerator Water Line Kit 1/4 Water O.D. I'd try my local Ace and give up if it isn't there. Ice Maker Water Line Brass Compression Tube Fitting, 1/4 OD x 1/4 OD (2). I could swear I've seen these with a collar nut on the female side (like how a female hose end works) that allows you to clock it correctly (though I guess pretty much angle angle would work with a hose). Click to expand.Close, but with that fitting, you can't determine where it stops.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |